2014 Buick Verano Owner Manual - Page 111

Instruments and Controls 5-5 Compass The vehicle may have a compass display on the Driver Information Center (DIC). The compass receives its heading and other information from the Global Positioning System (GPS) antenna, StabiliTrak®, and vehicle speed information. The compass system is designed to operate for a certain number of miles or degrees of turn before needing a signal from the GPS satellites. When the compass display shows CAL, drive the vehicle for a short distance in an open area where it can receive a GPS signal. The compass system will automatically determine when a GPS signal is restored and provide a heading again. See Compass Messages on page 5-27 for the messages that may be displayed for the compass. Clock The infotainment system controls are used to access the time and date settings through the menu system. The clock menu can be only be used with the radio on while in ON/RUN or ACC/ACCESSORY. See Operation on page 7-5 for information about how to use the menu system. 4. Press TUNE/MENU to select the next number. 5. To save the time and return to the Time and Date menu, press / BACK at any time or press the TUNE/MENU knob after adjusting the minutes. Setting the 12/24 Hour Format 1. Press the CONFIG button and select Time and Date or press H. 2. Highlight 12/24 Hour Format. 3. Press TUNE/MENU to select the 12 hour or 24 hour display format. Setting the Clock (Radio with CD) To set the time: 1. Press the CONFIG button and select Time and Date or press H. 2. Select Set Time. 3. Turn the TUNE/MENU knob to adjust the highlighted number.