2014 Buick Verano Owner Manual - Page 183

Infotainment System Using the "Digit Dial" Command The digit dial command allows a phone number to be dialed by entering the digits one at a time. After each digit is entered, the system repeats back the digit it heard followed by a tone. If an unwanted number is recognized by the system, say "Clear" at any time to clear the last number. To hear all of the numbers recognized by the system, say "Verify" at any time. 1. Press b / g. The system responds "Ready," followed by a tone. 2. Say "Digit Dial." 3. Say each digit, one at a time, that you want to dial. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say "Dial." Once connected, the person called will be heard through the audio speakers. Using the "Re-dial" Command 1. Press b / g. The system responds "Ready," followed by a tone. 2. After the tone, say "Re-dial." The system dials the last number called from the connected cell phone. Once connected, the person called will be heard through the audio speakers. 7-29 Call Waiting Call waiting must be supported on the cell phone and enabled by the wireless service carrier. . Press b / g to answer an incoming call when another call is active. The original call is placed on hold. Press b / g again to return to the original call. To ignore the incoming call, no action is required. Press $ / i to disconnect the current call and switch to the call on hold. . . . Receiving a Call When an incoming call is received, the audio system mutes and a ring tone is heard in the vehicle... Three-Way Calling Three-way calling must be supported on the cell phone and enabled by the wireless service carrier. 1. While on a call, press 2. Say "Three-way call." b / g to answer the call. Press $ / i to ignore a call. Press b / g.