2014 Buick Verano Owner Manual - Page 35

Keys, Doors, and Windows 2. Insert the vehicle key of the new transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4 or 5. removed to access the transmitter pocket. Use a finger or a tool in the notch at the rear of the cupholders to remove the liner. See Cupholders on page 4-2. 4. Press the ENGINE START/ STOP button. When the transmitter is learned, the DIC will show that it is ready to program the next transmitter. 5. Remove the transmitter from the transmitter pocket and press K. To program additional transmitters, repeat Steps 3-5. When all additional transmitters are programmed, press and hold the ignition for at least 10 seconds to exit programming mode. 3. Place the new transmitter into the transmitter pocket with the buttons facing up. The transmitter pocket is inside the center console cupholder. The cupholder liner will need to be 2-7 Programming without a Recognized Transmitter (Keyless Access Vehicles Only) Program a new key to the vehicle when a recognized key is not available. Canadian regulations require that owners see their dealer. 1. Insert the vehicle key of the transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT. 2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press the ignition. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.