2014 Buick Verano Owner Manual - Page 36

2-8 Keys, Doors, and Windows The cupholder liner will need to be removed to access the transmitter pocket. Use a finger or a tool in the notch at the rear of the cupholders to remove the liner. See Cupholders on page 4-2. 5. Press the ENGINE START/ STOP button. When the transmitter is learned, the DIC will show that it is ready to program the next transmitter. 6. Remove the transmitter from the transmitter pocket and press K. To program additional transmitters, repeat Steps 4-6. When all additional transmitters are programmed, press and hold the ignition for at least 10 seconds to exit programming mode. 3. Repeat Step 2 two additional times. After the third time all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1. Starting the Vehicle with a Low Transmitter Battery When trying to start the vehicle, if the transmitter battery is weak, the DIC may display NO REMOTE DETECTED or NO REMOTE KEY DETECTED, PLACE KEY IN TRANSMITTER POCKET, THEN START YOUR VEHICLE. The REPLACE BATTERY IN REMOTE KEY message may also be displayed at this time. To start the vehicle: 1. Remove the cupholder liner from the center console cupholder. See Cupholders on page 4-2. 2. Place the transmitter in the transmitter pocket with the buttons facing up. 4. Place the new transmitter into the transmitter pocket with the buttons facing up. The transmitter pocket is inside the center console cupholder.