2014 Buick Verano Owner Manual - Page 38

2-10 Keys, Doors, and Windows 2. Press and release Q. 3. Immediately after completing Step 2, press and hold / for at least four seconds or until the turn signal lamps flash. The turn signal lamps flashing confirms the request to remote start the vehicle has been received. When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on. The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once. Start the vehicle before driving. Extending Engine Run Time For a 10-minute extension, repeat Steps 1-3 while the engine is still running. The remote start can be extended once. When the remote start is extended, the second 10 minutes will start immediately. For example, if the engine has been running for five minutes, and 10 minutes are added, the engine will run for a total of 15 minutes. A maximum of two remote starts, or a single start with an extension, is allowed between ignition cycles. The vehicle's ignition must be turned on and then back off before the remote start procedure can be used again. Canceling a Remote Start To cancel a remote start, do one of the following: . Conditions in Which Remote Start Will Not Work The remote vehicle start feature will not operate if: . The key is in the ignition (key access) or if the key is in the vehicle (keyless access). The hood is not closed. The hazard warning flashers are on. The malfunction indicator lamp is on. The engine coolant temperature is too high. The oil pressure is low. Two remote vehicle starts, or a single remote start with an extension, have already been used. The vehicle is not in P (Park). . . . . . . Aim the RKE transmitter at the vehicle and press and hold / until the parking lamps turn off. Turn on the hazard warning flashers. Turn the vehicle on and then off. . . .