1995 Cadillac Seville Owner's Manual - Page 293

How to Add Fluid Refer to the Maintenance Schedule to determinewhat kind of transaxle fluid to use. If the fluid level is low, add only enough of the properfluid to bring the level into thecross-hatched area on the dipstick. 1. Pull out the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper level. It doesn't take much fluid, generally less than a pint (OSL). Don't ove@ZZ. We recommend you use only fluid labeled DEXRON@-111,because fluid with that label is made especially for your automatic transaxle. Damage caused by fluid other than DEXRON@-I11is not covered by your new vehiclewarranty. After adding fluid, recheck the fluid level as described under "How to Check." When the correct fluid level is obtained, push the dipstick back in all the way. How to Reset Transaxle Fluid Change Indicator Your vehicle is equipped with a transaxle fluid change indicator. A CHANGE TRANS FLUID message will displayon the Information Center when the powertrain computer determines that the transaxle fluid needs to be changed or ateach 100,000miles (160 000 km) interval, whichever occurs first. When thismessage appears, change the transaxle fluid and reset thetransaxle fluid life indicator as follows: 1. Turn the key ON but do not start the engine. 2. Press and hold the OFF and REAR DEFOG buttons on the climate control simultaneously until the TRANS FLUID RESETmessage appears in the Information Center (between five and 20 seconds). 6-22