1995 Cadillac Seville Owner's Manual - Page 320

- c Warning: The temperature grade for tire is established for a tire that this is properly inflated and not overloaded. Excessive speed, underinflation, or excessive loading, either separately or combination, can cause heat in buildup andpossible tire failure. These gradesare molded on the sidewalls of passenger cartires. While the tires available as standard or optional equipment on General Motors vehicles may vary withrespect to these grades, all such tires meet General Motors performance standards and been approved foruse have on General Motorsvehicles. All passenger type (P Metric) tiresmust conform to Federal safety requirements in addition to these grades. Wheel Alignmentand Tire Balance The wheels on your vehicle were aligned and balancedcarefully at the factory to give you the longest tirelife and best overall performance. In most cases, you will not needto have your wheels aligned again. wear or your vehicle pulling one way However, if you notice unusual tire or the other, the alignment need tobe reset. If you notice your may vehicle vibrating when driving on a smooth road, wheels may need to your be rebalanced. Wheel Replacement Replace any wheel that is bent, cracked,or badly rusted or corroded. If wheel nuts keepcoming loose, the wheel, wheel bolts, and wheel nuts should be replaced. the wheel leaks air, replaceit (except some If aluminum wheels, which can sometimes be repaired). See Cadillac your dealer if any of these conditionsexist. Your dealer will know the kind of wheel you need. Each new wheel should have the same load carrying capacity, diameter, width, offset, and be mounted the same as the one it replaces. way - If you need to replaceany of your wheels, wheel bolts, or wheel nuts, replace themonly with new GM original equipment parts. This way, you will be sure to have the right wheel, wheel bolts, and wheel nuts foryour Cadillac model. 6-49