1996 Cadillac Eldorado Owner's Manual - Page 142

1996 Cadillac Eldorado Manual

Page 142 highlights

ENGINE COOLANTHOT-IDLE ENGINE 44: This message will appear when the engine coolant 248 temperature is over O F (126°C). To avoid added strain on a hot engine, turn off the climate control system. Stopand allow your vehicle to idle until it cools down or the message is removed. If it does not cool down, turn off the engineand have it serviced before driving it again. Severe enginedamage can result from an overheated engine. See "Engine Overheating" in the Index. FUEL LEVELVERY LOW 11: This message serves as a warning that the fuellevel in the tank is critically low. Stop for fuel immediately. MONITORED SYSTEMS OK 1: This messageonly appears in the "recall"mode by pressing theRESET button. It lets you know that no other messagesare stored or currentlyactive. PASS KEY NOT PROGRAMMED 31: This warning message displayswhen the PASS-Key pellet information has not been programmed into your vehicle. See your Cadillac dealership for service. - PCM FAULT 110: The circuit in the Powertrain Control Module (PCM) has shorted or is loose when this message appears.Have your Cadillac serviced by your dealership at once. - REDUCED ENGINE POWER 41: This message informs the driver due to wheel slippage your that vehicle is reducing engine power to compensate forthe loss of traction. Accelerating too fast causing thetires to spin is an example of when this message would display. REMOVE KEY 70: This messagewill appear when the Personalized Automotive Security System (PASS-Key 11) is unable to read the pellet on the ignition key or an improper key pellet has been inserted. Wait for theDIC to display STARTING DISABLED DUE TO THEFT SYSTEM REMOVE IGNITION KEY. The instrumentpanel cluster will then run a timer and change themessages to WAIT 3 MINUTES, WAIT 2 MINUTES, WAIT 1 MINUTE and then START CAR. When the REMOVE KEY message is displayed, remove the ignition key. Check the ignition key for damage. If it is damaged, it may need to be replaced. If you see no damage, clean the pellet contacts with a soft cloth or - - - - - 2-81

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.