1996 Cadillac Eldorado Owner's Manual - Page 168

TAPE: Press this button to switch from radio or CD to cassette tape play. Press AM or FM 1-2 to switch to the radio. SEEK: Press the forward arrowto search for the next selection on the tape. Press thebackward arrow to search for the previous selection on the tape (REP will appear on the display). Your tape must have at least three secondsof silence between each selection for SEEK to work. The sound will be muted while seeking. SCAN: Press this button. SCAN will appear on the display until the next selection is found and then PLAY will appear on the display. Use SCAN to listen to selections for a few seconds. Thetape will go to a selection, stop for a few seconds, then go to the next on station. Press this button again to stop scanning. A (EJECT): Press the upward triangle button to remove a tape. The radiowill play. Eject may be activated with the radiooff if the ignition is on. Cassette tapes may be loaded with the radiooff but they will not start playing until the PWR button is turned on. Press PWR or turn the ignition key OFF to stop the cassette tape player. The tapewill stay in the player and resume play at the point where it stopped. REV: Press this left arrow button to reverse the tape rapidly. Press it again return to playiag speed. The to radio will play while the tape reverses REV will and appear on the display. You may use your station pushbuttons to tune to another radiostation while in REV mode. FF: Press this right arrow buttonto advance quickly to another part of the tape. Press thebutton again to return to playing speed. The radiowill play while the tape advances and FWD will appear on the display. You may use your station pushbuttons to tune to another radio station while in F W D mode. SIDE: Press this button to change theside of the tape that is playing. CLN: This message may appe-af ijn the display. If it does, your cassette tape playerneeds to be cleaned. It will still play tapes, but you should clean it as soon as possible to prevent damageto your tapes and player. See "Careof Your Cassette Tape Player" in the Index. After you clean theplayer, press and hold EJECT for five secondsto reset the CLN indicator. The radiowill display --- to show the indicator was reset. is Dolby@ Noise Reduction manufactured under a license from Dolby Laboratories Licensing Corporation. Dolby and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. 3-21