1998 Cadillac Eldorado Owner's Manual - Page 123

This device complies with RSS-210 of Industry Canada. Operation is subject tothe following two conditions: (1j this devicemay not cause interference, and (2) this device must accept any interference, including of interference thatmay cause undesired operation the device. Changes and modifications to this system by other than an authorized service facilitycould void authorization to use this equipment. the two outside buttonson the universal transmitter until the amber light begins to flash rapidly (approximately 20 seconds). Then release the buttons. Thisprocedure initializes the memory and erases any previous settings forall three channels. 2 . Decide which one of the three channels you want to program. Programming the Transmitter Do not use the universal transmitter with any garage door opener that does not have the "stop and reverse" safety feature. This includesany garage door opener model manufactured before April 1, 1982. Be sure that people and objects are clearof the garage door you are programming. Your vehicle's engine should be turned off while programming the transmitter. Follow these steps to program up to three channels: 1. If you have previously programmed a transmitter channel, proceed to Step 2. Otherwise, hold down 3. Hold the end of the hand-held transmitter against the front surfaceof the universal transmitter so that you can still see the amber light. 4. Using both hands, press the hand-held transmitter button and the desired button on the universal transmitter. Continue to press both buttons through Step 5. 5. Hold down both buttons until you see the amber light on the universal transmitter flash slowly and then rapidly. The rapid flashing,which could takeup the to 90 seconds, indicates that universal transmitter has been programmed. Release both buttons once the light startsto flash rapidly. 2-53