1998 Cadillac Eldorado Owner's Manual - Page 125

Training a Garage Door Opener with "Rolling Codes"(If Equipped) If you have not previously programmed the hand-held transmitter to the universal transmitter. see "Programming the Transmitter" earlier in this section. If you have completed this programming already. you now need to train the garage door opener receiver to recognize the universal transmitter. Refer to your garage door opener owner's manual for the proper transmitter training procedure for your garage door opener brand. transmitter has been trained to the garage door opener receiver. Check that the training was successful. The receiver light should no longer be flashing. The garage door opener should now recognize the universal transmitter. You may either use the universal transmitter orthe hand-held transmitter toopen the garage door. If after following these instructions still have you problems training the garage door opener, consult your dealer. 1. Locate the training button on the garage door opener receiver. The exact locationand color of the button may vary by garage door opener brand. If you have difficulty locating the training button. refer to your garage door opener manual. Erasing Channels To erase all three-programmed channels,hold down the two outside buttons until red light begins to the flash. Individual channels cannot be erased, but can be reprogrammed using the procedure for Programming the transmitter explained earlier. 2 . Press the training button on the garage door opener A receiver for one or two seconds. light indicator will begin to flash when the receiver enters the train mode. 3. Return to the universal transmitter in your vehicle and press the universal transmitter button you have already programmed for two to three seconds. Press the button again to make surethat the universal Accessories Accessories forthe universal transmitter are available from the manufacturer of the unit. If you would like additional information, please call 1-800-355-35 15. 2-55