1998 Cadillac Eldorado Owner's Manual - Page 168

Playing a Cassette Tape With the radio on, insert a cassette tape. The tape will begin playing as soon as it is inserted.When one side of your cassette tape is done playing, auto reverse plays the other sideof your cassette tape. If you want to insert a cassette tape when the ignition is off, first press EJECT. use While the tape is playing, the VOL, FADE, BAL, BASS and TREB controls just as you do for the radio. Other controls may have different functions when tape is a inserted. The display will show TAPE with an arrow to indicate which sideof the tape is playing. PLAY will appear on the display temporarily whena tape is playing. The display will then revert back to showing time. the REV Press the left arrow to rewind the tape rapidly. The radio will play while the tape reverses and REV will appear on the display. You may use your station pushbuttons to tune to another radio station while in REV mode. Press the left arrow again to return to playing speed. FF: Press the right arrow to fast forward to another part of the tape. The radio will play while the tape advances and FF will appear on the display. You may use your station pushbuttons to tune to another radio station while in FF mode. Press the right arrow again to return to playing speed. If an error occurs while trying toplay a cassette tape, it could be that: The cassette tape is tight and the cassette player cannot turn the hubs of the tape. Hold the cassette tape with the open end down and try turning the right hub to the left with a pencil. Flip the tape over and repeat. If the hubs do not turn easily, your cassette tape may be damaged and should not be used in the player. Try a new tape to be sure your player is working properly. The cassette tape is broken. (Check to see if your tape is broken. Try a new tape.) SEEK-TUNE: Press the right arrow to seek tothe next selection on the tape. Press the left arrow to search for the previous selection'on the tape (REP will appear on the display). Your tape must have at least three seconds of silence between each selection for SEEK-TUNE to work. The sound will mute while seeking. SCAN: Press this button. SCAN FF will appear on the display until the next selection is found and then SCAN PLAY will appear on the display. Use SCAN to listen to selections for a few seconds. Thetape will go to a selection, stop fora few seconds, then go on to the next selection. Press this button again to stop scanning. SIDE: Press this button to change the side of the tape that is playing. (PLAY shows on the display.) 3-12