2001 Chevrolet Corvette Owner's Manual - Page 111

Setting Cruise Control Resuming a Set Speed Suppose you set the cruise control at a desired speed and then you apply the brake or clutch pedal. This, of course, disengages the cruise control. But you don't need to reset it. Once you're going about 25 mph (40 km/h) or more, you can move the cruise control switch to R/A (Resume/Accelerate) briefly. The Driver Information Center (DIC) will display the cruise set speed. You'll go right back up to your chosen speed and stay there. Increasing Speed While Using Cruise Control There are two ways to go to a higher speed: CAUTION: If you leave your cruise control switch on when you're not using cruise, you might hit a button and go into cruise when you don't want to. You could be startled and even lose control. Keep the cruise control switch off until you want to use cruise control. 1. Move the cruise control switch to ON. 2. Get up to the speed you want. 3. Push the SET button at the end of the lever and release it. The cruise set speed will be displayed by the Driver Information Center (DIC). 4. Take your foot off the accelerator pedal. The pedal will return to an "idle" position. D Use the accelerator pedal to get to the higher speed. The speed will not begin to increase until sufficient pedal travel is achieved. Push the SET button at the end of the lever, then release the button and the accelerator pedal. You'll now cruise at the higher speed. 2-49