2009 Chevrolet Cobalt Owner's Manual - Page 186

Playing the Radio O (Power/Volume): Press to turn the system on and off. Turn to increase or decrease the volume. Speed Compensated Volume (SCV): Radios with the Speed Compensated Volume (SCV) feature automatically adjust the radio volume to compensate for road and wind noise as the vehicle speeds up or slows down, so that the volume level is consistent. To activate SCV: 1. Set the radio volume to the desired level. 2. Press MENU to display the radio setup menu. 3. Press the softkey under the AUTO VOLUM tab on the radio display. 4. Press the softkey under the desired Speed Compensated Volume setting (OFF, Low, Med, or High) to select the level of radio volume compensation. The display times out after approximately 10 seconds. Each higher setting allows for more radio volume compensation at faster vehicle speeds. Finding a Station BAND: Press to choose between FM1, FM2, AM, or XM™ (if equipped) on the Radio with CD (Base). Press to choose between FM, AM, XM (if equipped) on the Radio with CD (MP3) and USB Port or the Radio with CD (MP3). f (Tune): Turn to select radio stations. ©SEEK: Press to seek or scan stations with a strong signal in the selected band. • To seek stations, press and release ©SEEK to go to the previous station and stay there. • To scan stations, press and hold ©SEEK for a few seconds until the radio beeps once. The radio goes to a station, plays for a few seconds, then goes to the next station. Press ©SEEK again to stop scanning. • To scan preset stations in the selected band, press and hold ©SEEK for four seconds until a double beep sounds. The radio goes to a stored preset, plays for a few seconds, then goes to the next stored preset. Press ©SEEK again to stop scanning preset stations. 3-62