2004 Chrysler Sebring Owner's Manual - Page 73

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 73 5. The indicator light in the Universal Transceiver will begin to flash, first slowly and then rapidly. The rapid flashing indicates successful programming. If after 90 seconds the indicator light does not flash rapidly or goes out, return to step 1 and repeat the procedure. To train the other buttons, repeat steps 3 and 4. Be sure to keep your hand held transmitters in case you need to retrain the Universal Transceiver. NOTE: If you do not successfully program the Universal Transceiver to learn the signal of your hand held transmitter, refer to the Rolling Code Paragraph, or call toll free for customer assistance at 1-800-355-3515, or on the internet at www.homelink.com. "Rolling Code" Programming NOTE: If your hand held transmitter appears to program the Universal Transceiver, but your garage door or other device does not operate, and your device was manufactured after 1996, your garage door opener or other device may have a "Rolling Code" system. On garage door openers with the "Rolling Code" feature, the transmitter code changes after each use to prevent the copying of your code. To check if your device is protected by a "Rolling Code" system: • Check the owner's manual for the device for mention of "Rolling Codes". • Press and hold the programmed button on the Universal Transceiver. If the Universal Transceiver indicator light flashes rapidly and then stays on after 2 seconds, the device has the "Rolling Code" feature. To train a garage door opener (or other rolling code equipped devices) with the rolling code feature, follow these instructions after completing the Programming portion of this text: NOTE: The assistance of a second person may make the following programming procedure quicker and easier. 3