2005 Chrysler Sebring Owner Manual Coupe - Page 135
2005 Chrysler Sebring Manual
Page 135 highlights
INSTRUMENTS AND CONTROLS 135 NOTE: • Some entry gates and garage door openers may require you to replace step 4 with the procedures listed under Canadian Programming. 5. The indicator light (D) will begin to flash, first slowly and then rapidly. The rapid flashing indicates successful programming. If after 90 seconds the indicator light does not flash rapidly or goes out, return to step 1 and repeat the procedure. To train the other buttons, repeat steps 3 and 4. Be sure to keep your hand held transmitters in case you need to retrain the universal transceiver. Refer to the Rolling Code Programming or the Canadian/Gate paragraphs for additional procedures, if necessary. If you do not successfully program the universal transceiver to learn the signal of your hand held transmitter, refer to the Rolling Code Paragraph, or call toll-free for customer assistance at 1-800-355-3515, or on the internet at www.homelink.jci.com. Canadian Programming/Gate Programming Canadian frequency laws, and the technology of some entry gates, require you to press and release the hand held transmitter button every two seconds during programming. Continue to press and hold the universal transceiver button (A, B or C) while you press and release the hand held transmitter button until the frequency signal has been learned. The indicator light (D) will flash slowly and then rapidly when the programming is successful. NOTE: • When programming such a garage door opener or gate, unplug the device to prevent possible damage to the garage door or gate motor. 4