2005 Chrysler Sebring Owner Manual Coupe - Page 328

328 MAINTENANCE HOOD LOCK RELEASE MECHANISM AND SAFETY CATCH The hood lock release mechanism and hood safety catch should be inspected, cleaned, and lubricated as required to maintain ease of operation and to provide protection against rust and wear. Apply Multipurpose Grease NLGI Grade 2 sparingly to all sliding contact areas of the hood latch and release lever. Work lubricant into the hood lock mechanism until all frictional surfaces are covered. Also, apply a film of the same lubricant to the pivot contact areas of the safety catch. EXHAUST SYSTEM Whenever a change is noticed in the sound of the exhaust system; when exhaust fumes can be detected inside the vehicle; or when the underside or rear of the vehicle is damaged, have a competent technician inspect the complete exhaust system and adjacent body areas for broken, damaged, deteriorated, or mispositioned parts. In addition inspect the exhaust system each time the vehicle is raised for lubrication or oil change. Replace as required. Open seams or loose connections could permit dangerous exhaust fumes to seep into the trunk and passenger compartments. Do this service when performing underbody service. Check for any of the following conditions: 1. Check for holes or exhaust gas leakage caused by corrosion or damage. 2. Check the joints and connections for looseness or exhaust gas leakage. 3. Check the rubber hangers and brackets for damage. WARNING! Carbon monoxide gas found in the vehicle's exhaust is poisonous. Inhalation of exhaust fumes can cause unconsciousness or death. The best protection against carbon monoxide entry into the vehicle interior is a properly maintained engine exhaust system.