2005 Ford Explorer Sport Trac Quick Reference Guide 1st Printing - Page 9

4X4 LOW uses extra gearing to provide maximum power to all four wheels. To shift between 2WD and 4X4 HIGH: Turn the control between the 2WD and the 4X4 HIGH position at any forward speed, as long as the rear wheels are NOT slipping. To shift to or from 4X4 LOW: Bring the vehicle to a complete stop. Press the brake. Place the gearshift in N (Neutral), and then turn the control to the desired position. 12 Speed Control (if equipped) To operate, the speed control must be ON and the vehicle's speed must be at or above 30 mph (48 km/h). To set a speed, press SET ACC. To set a higher speed, press SET ACC again. To set a lower speed, press COAST. Pressing RSM will return to a previously set speed. To turn the speed control off, press the OFF button or turn off the vehicle's ignition. Press the brake pedal to disengage. 8 Premium Dual Media Radio (if equipped) Please see reverse side for more details. 9 In Dash Six-CD Radio (if equipped) 13 Hood Release Please see reverse side for more details. 10 Power Down Back Window Control Turn counterclockwise and release to lower the window to the full-open position. Turn the control clockwise and release to raise the window to the full-closed position. Press once to move the window (up or down) to the vent position. If the window is already in the vent position and the control is pressed, no movement will occur. To operate the power down back window, the ignition switch must be in the ON or ACC position. All rear-seat occupants and/or cargo must be properly restrained and clear of the back window opening before operating the power down back window. Inside the vehicle, pull the hood release handle under the bottom of the instrument panel near the steering column. Next, release the auxiliary latch located in the center between the hood and the grille. Lift the hood and secure it with the prop rod. Turn 14 Turn Signal and Wiper/Washer Control Rotate the end of the control to increase or decrease the speed of the wipers. When the wiper control is on, the speed of the wipers will automatically adjust with the vehicle's speed. Push the control on the end of the lever briefly for a single wipe (no wash). Push and hold for three wipes with a wash. A long push and hold will activate a longer wash cycle (up to ten seconds). The Explorer Sport Trac is also equipped with a rear window wiper and washer control, located to the right of your audio system. Turn the control clockwise to the desired interval speed. Press to activate the washer fluid. For extended wiper blade quality, occasional cleaning of the wiper blades is required. 11 Climate Control System Please see reverse side for more details.