2010 Ford Expedition EL Owner Guide 3rd Printing - Page 23

Instrument Cluster 5. Press and hold the SELECT/RESET stem until the message center displays CIRCLE SLOWLY TO CALIBRATE. This step may require up to five circles to complete the calibration. NOTE: If the SELECT/RESET stem is pressed during the calibration or three minutes has elapsed since the beginning of the calibration without driving the vehicle, the message center reverts back to normal operation and the CAL will display until a successful calibration is carried out. 6. Slowly drive the vehicle in a circle less than 3 mph (5 km/h ) until the CIRCLE SLOWLY TO CALIBRATE message changes to CALIBRATION COMPLETED. Setup menu (vehicle customization and vehicle system check) HOLD RESET FOR SETUP MENU Press and hold the SELECT/RESET stem to get into the setup menu sequence for the following displays: Note: When returning to the SETUP menu and a non-English language has been selected, HOLD RESET FOR ENGLISH will be displayed to change back to English. Press and hold the SELECT/RESET stem to change back to English. HOLD RESET FOR SYSTEM CHECK Press and hold the SELECT/RESET stem to start the system check when HOLD RESET FOR SYSTEM CHECK is displayed in the message center. For each of the monitored systems, the message center will indicate either an ok message or a warning message for two seconds. Pressing the SELECT/RESET stem cycles the message center through each of the systems being monitored. Note: Some systems show a message only if a condition is present. 1. OIL LIFE 2. CHARGING SYSTEM 3. WASHER FLUID LEVEL 4. DOOR/LIFTGATE/GLASS AJAR 5. BRAKE SYSTEM 6. TIRE PRESSURE 7. FUEL LEVEL (will only display if 50 miles or less to empty) 8. MYKEY DISTANCE (if programmed) 9. MYKEY(S) PROGRAMMED 10. ADMIN KEYS PROGRAMMED 23 2010 Expedition (exd) Owners Guide, 3rd Printing USA (fus)