2011 Ford Expedition Owner Guide 1st Printing - Page 104
2011 Ford Expedition Manual
Page 104 highlights
Driver Controls To program another rolling code device such as an additional garage door opener, a security device or home lighting, repeat Steps 1 through 4 substituting a different function button in Step 3 than what you used for the garage door opener. For example, you could assign the left-most button to the garage door, the center button to a security device, and the right-most button to another garage door opener. Note: The Car2U system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it is necessary to erase the current settings using the Erasing the Car2U Home Automation System buttons procedure and then programming all of the devices being used. Fixed code programming Note: Do not program the Car2U system with the vehicle in the garage. Make sure that your key is on and engine off while programming the transmitter. 1. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 2. Open the battery cover and record the switch settings from left to right for all 8 to 12 switches. Use the figure below: When a switch is in the up, on, or + position, circle "L." When a switch is in the middle, neutral, or 0 position, circle "M." When a switch is in the down, off, or - position, circle "R." Switch position 1 2 3 4 5 6 7 Up, on or + L L L L L L L Middle, neutral or 0 M M M M M M M Down, off or - R R R R R R R L=left; M=middle; R=right 104 8 L M R 9 L M R 10 11 12 L L L M M M R R R 2011 Expedition (exd) Owners Guide, 1st Printing USA (fus)