2012 Ford F250 Super Duty Owner Guide 4th Printing - Page 131

Locks and Security For optional message center: 1. At the main menu screen select SETTING then MYKEY by pressing OK or the right arrow key. 2. Press OK to select CREATE MYKEY. 3. Hold OK as prompted until you see MARK THIS KEY AS RESTRICTED. MyKey௡ is successfully programmed. Make sure you label it so you can distinguish it from the admin keys. Note: To program the optional settings go to Step 2 in the Programming MyKey௡ optional settings section. If your vehicle is equipped with remote start, see the Using MyKey௡ with remote start systems section. Note: The MyKey௡ can be cleared within the same key cycle that it was created, otherwise a standard key (administrator key) is required to clear the MyKey௡ programming. To clear all MyKeys௡ go to Step 2 in the Clear MyKey௡ section. Programming MyKey௡ optional settings To program the optional settings, use the message center buttons to do the following: For standard message center: 1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed. 2. Press and release the RESET button to display MyKey௡ setup menus. The first menu shown is: MYKEY MAX MPH OFF 3. If you don't want to change the maximum speed setting, press the SETUP button to display the next menu. The remaining menus appear as follows with the default settings shown: MYKEY MPH TONES 45 55 65 MYKEY VOLUME LIMIT OFF MYKEY ADVTRAC CTRL ON . 4. On any of the menus press RESET to highlight your choice with the . 5. Press SETUP to enter your choice. The next optional setting will be displayed. 6. Repeat Steps 4 and 5 until you are done changing the optional settings. 131 2012 F-250/350/450/550 (f23) Owners Guide, 4th Printing USA (fus)