2012 Ford F250 Super Duty Owner Guide 4th Printing - Page 144

Locks and Security 2. Press and hold control button 1 for five seconds. A tone will be heard after two seconds confirming memory position has been set. Continue to hold until a second tone is heard after five seconds. 3. Within three seconds press 4. Wait 10 seconds, then press . . 5. Repeat this procedure for memory 2 and another transmitter if desired. Deprogramming memory feature from transmitter To deactivate this feature: 1. Press and hold either the 1 or 2 control on the driver's door for five seconds. A tone will be heard after 11⁄2 seconds when the memory store is done, continue to hold until a second tone is heard after five seconds. 2. Within three seconds press . 3. Repeat this procedure for another transmitter if desired. Replacing the battery The integrated keyhead transmitter (IKT) or intelligent access key (IA key) uses one coin type three-volt lithium battery CR2032 or equivalent. Integrated keyhead transmitter (IKT) To replace the battery: 1. Twist a thin coin in the slot near 1 the key ring to remove the battery cover (1). 2 Note: Do not wipe off any grease on the battery terminals on the back surface of the circuit board. 3 2. Carefully peel up the rubber gasket (2) from the transmitter if it does not come off with battery cover. 3. Remove the old battery (3). Note: Please refer to local regulations when disposing of transmitter batteries. 144 2012 F-250/350/450/550 (f23) Owners Guide, 4th Printing USA (fus)