2013 Ford C-MAX Energi Owner Manual Printing 3 - Page 170

Universal Garage Door Opener (If Equipped) 169 Programming HomeLink to a Genie Intellicode 2 garage door opener Note: The Genie Intellicode 2 transmitter must already be programmed to operate with the garage door opener. Programing the transmitters To program HomeLink to the transmitter you must first put the transmitter into programming mode. To do this: A. Red LED B. Green LED A B 1. Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The LED light will change from green to green and red. 2. Press the same button twice to confirm the change to Programming mode. If done properly the LED light will appear red. 3. Hold the transmitter within 1-3 inches (2-8 centimeters) of the button on the sun visor you want to program. 4. Press and hold both the programmed Genie button on the hand-held transmitter and the button on the sun visor you want to program. The indicator light on the sun visor will flash rapidly when the programming is successful. Note: the Genie transmitter will transmit for up to 30 seconds. If HomeLink does not program within 30 seconds the Genie transmitter will need to be pressed again. If the Genie transmitter LED displays green and red, release the button until the LED turns off before pressing the button again. Once HomeLink has been programmed successfully, the Genie transmitter must be changed out of program mode. To do this: 1. Press and hold the previously programmed Genie button on the hand-held transmitter for 10 seconds. The indicator light will change from red to red and green. 2. Press the same button twice to confirm the change. If done correctly the LED will turn green. 2013 C-Max Full Hybrid (34h) Owners Guide gf, 3rd Printing, January 2013 USA (fus)