2013 Ford Fiesta Owner Manual Printing 2 - Page 62

Keys and Remote Control 61 Car Finder Press the lock button on the key twice within three seconds. The horn will sound and the turn signals will flash. We recommend you use this method to locate your vehicle, rather than using the panic alarm. REPLACING A LOST KEY OR REMOTE CONTROL Replacement or additional keys or remote controls can be purchased from your authorized dealer. Your dealer can program the transmitters to your vehicle or you may be able to program them yourself. See the Security chapter for information on programming your keys. Reprogramming Your Remote Control Note: You can only program an integrated keyhead transmitter. See your authorized dealer to have an intelligent access transmitter programmed. You must have all remote controls available before beginning this procedure. If all remote controls are not present during programming, the ones missing will no longer operate the vehicle. To reprogram the remote control: 1. Turn the ignition switch from off to run four times in rapid succession (within six seconds), with the fourth turn ending in off. If the program mode is successfully entered, a chime will sound. Note: If no action is taken within 10 seconds after a transmitter has been programmed, the programming sequence ends. 2. Within 10 seconds, press any button on the transmitter to be programmed. A chime will sound to confirm that the transmitter is programmed. Repeat this step for each transmitter. Note: There is no chime or any other confirmation upon exiting the programming mode. 3. Exiting the programming mode is accomplished if one of the following occurs: • The ignition is turned on. • Ten seconds have passed since entering the programming mode or since the last transmitter was programmed. • The maximum number (eight) of transmitters has been programmed. 2013 Fiesta (fie) Owners Guide gf, 2nd Printing USA (fus)