2014 Ford E150 Passenger Owner Manual Printing 1 - Page 87

86 Information Displays Note: If the SELECT/RESET stem is pressed during the calibration or three minutes has elapsed since the beginning of the calibration without driving the vehicle, the message center reverts back to normal operation and the CAL will display until a successful calibration is carried out. 1. Press and release the SELECT/RESET stem to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU. 2. Press and hold the SELECT/RESET stem to get into the setup menu. Repeatedly press it again to scroll through the setup menu until the message center displays HOLD RESET FOR CALIBRATION. 3. Press and hold the SELECT/RESET stem for approximately two seconds until the message center enters the compass zone adjustment mode. 4. Press and hold the SELECT/RESET stem until the message center displays CIRCLE SLOWLY TO CALIBRATE. 5. Slowly drive the vehicle in a circle less than 3 mph (5 km/h ) until the CIRCLE SLOWLY TO CALIBRATE message changes to CALIBRATION COMPLETED. This may require up to five circles to complete the calibration. • TBC MODE (if equipped): Allows you to choose the trailer brake mode. • LANGUAGE = ENGLISH / SPANISH / FRENCH: Allows you to choose which language the message center will display in. Waiting four seconds or pressing the SELECT/RESET stem cycles the message center through each of the language choices. Press the SELECT/RESET stem to set the language choice when the language you want appears. • HOLD RESET FOR SYSTEM CHECK: The message center will begin to cycle through the vehicle systems and provide a status of the item if needed. Some systems show a message only if a condition is present. 2014 Econoline (eco) Owners Guide gf, 1st Printing, November 2012 USA (fus)