2015 Ford F450 Super Duty Crew Cab Diesel Supplement Printing 1 - Page 15

2015 Ford F450 Super Duty Crew Cab Manual

Get 2015 Ford F450 Super Duty Crew Cab PDF manuals and user guides View all 2015 Ford F450 Super Duty Crew Cab manuals

Page 15 highlights

Starting and Stopping the Engine WARNING To reduce the risk of vehicle damage and/or personal burn injuries do not start your engine with the air filter removed and do not remove it while the engine is running. In order to operate the engine in temperatures of 32°F (0°C) or lower, read the following instructions: • Make sure that the batteries are of sufficient size and are fully charged. Check other electrical components to make sure they are in optimum condition • Use the proper coolant solution at the concentration recommended protecting the engine against damage from freezing • Try to keep the fuel tank full as much as possible at the end of operation to prevent condensation in the fuel system • Make sure you use proper cold weather engine oil and that it is at its proper level. Also, if necessary, make sure to follow the engine oil and filter change schedule found under the Special operating conditions section listed in the scheduled maintenance information • At temperatures of -10°F (-23°C) or below, it is recommended that you use an engine block heater to improve cold engine starting • If operating in arctic temperatures of -20°F (-29°C) or lower, consult your truck dealer for information about special cold weather equipment and precautions The following cold weather idling guidelines are recommended: • You can use Motorcraft® cetane improvers or non-alcohol-based cetane improvers from a reputable manufacturer as needed. • Maintain the engine cooling system properly. • Avoid shutting the engine down after an extensive idling period. Drive your vehicle for several miles with the engine at normal operating temperatures under a moderate load. • Consider using an engine block heater. • For extended idle times use an approved idle speed increase device. Winter Operating Tips for Arctic Operation -20°F (-29°C) and Below The following information is a guideline only and is no to be the only source of possible solutions in resolving extreme cold temperature issues. Starting Aids WARNING Do not use starting fluid, such as ether, in the air intake system (see air filter decal). Such fluid could cause immediate explosive damage to the engine and possible personal injury. The use of the factory engine block heater assists in engine starting in extreme cold ambient temperatures. Refer to Engine block heater in the Starting and Stopping the Engine chapter of your Owner's Manual. 12 Super Duty (TFA) , enUSA

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
WARNING
To reduce the risk of vehicle damage
and/or personal burn injuries do not
start your engine with the air filter
removed and do not remove it while the
engine is running.
In order to operate the engine in
temperatures of 32°F (0°C) or lower, read
the following instructions:
•
Make sure that the batteries are of
sufficient size and are fully charged.
Check other electrical components to
make sure they are in optimum
condition
•
Use the proper coolant solution at the
concentration recommended
protecting the engine against damage
from freezing
•
Try to keep the fuel tank full as much
as possible at the end of operation to
prevent condensation in the fuel
system
•
Make sure you use proper cold weather
engine oil and that it is at its proper
level. Also, if necessary, make sure to
follow the engine oil and filter change
schedule found under the Special
operating conditions section listed in
the scheduled maintenance
information
•
At temperatures of -10°F (-23°C) or
below, it is recommended that you use
an engine block heater to improve cold
engine starting
•
If operating in arctic temperatures of
-20°F (-29°C) or lower, consult your
truck dealer for information about
special cold weather equipment and
precautions
The following cold weather idling
guidelines are recommended:
•
You can use Motorcraft® cetane
improvers or non-alcohol-based
cetane improvers from a reputable
manufacturer as needed.
•
Maintain the engine cooling system
properly.
•
Avoid shutting the engine down after
an extensive idling period. Drive your
vehicle for several miles with the
engine at normal operating
temperatures under a moderate load.
•
Consider using an engine block heater.
•
For extended idle times use an
approved idle speed increase device.
Winter Operating Tips for Arctic
Operation -20°F (-29°C) and Below
The following information is a guideline
only and is no to be the only source of
possible solutions in resolving extreme
cold temperature issues.
Starting Aids
WARNING
Do not use starting fluid, such as
ether, in the air intake system (see
air filter decal). Such fluid could
cause immediate explosive damage to the
engine and possible personal injury.
The use of the factory engine block heater
assists in engine starting in extreme cold
ambient temperatures. Refer to Engine
block heater in the Starting and Stopping
the Engine chapter of your Owner’s
Manual.
12
Super Duty (TFA) , enUSA
Starting and Stopping the Engine