1995 GMC Yukon Owner's Manual - Page 175

RCL (Recall) - Press this button to changebetween the clock and the radio station frequency displayed when the radio is on. Also, press this button to display the time when the ignition is off. TUNE - Press lightly on the TUNE button to release it from its stored position. Rotate the knob clockwise to increase frequency and counterclockwise to decrease radio frequency. When done, pressthe knob again to return it to its stored position. Pushbuttons - The six pushbuttons let you return to favorite stations. To set the pushbuttons for up to I8 favorite stations (6 AM, 6 FMI and 6 FM2): 1. Tune in the desired station. 2. Press AUTO TONEto select the best setting for the type of station chosen. 3. Press and hold one of the pushbuttons until sound returns (approximately two seconds). Whenever press that button, the you preset station will return. Repeat these steps for each pushbutton. SEEK - Press SEEK station. to cause the receiver to seek the next higher Press 4 SEEK to cause the receiver to seek the next lower station. SCAN - Press and hold the center of the SEEK button to momentarily hear each available station.Release the button when SCAN appears in the display. The receiver will continue to scan and momentarily stop at each station until you press the center of the SEEK button again. P. SCAN (Preset Scan) - Press this button to scan each preset pushbutton station. The receiver will continue to scanand momentarily stop at each station until you press either P. SCAN again or one of the six pushbuttons. The AUTO SCAN setting for that preset button will also return. The pushbutton number (PI-P6) will appear momentarily just before frequency is displayed. AUTO TONE - Press this button to select between five preset equalization settings and tailor the sound to the music or voice being heard. Each time you press the button, the selection will switch to one of the preset settings of CLASSIC, NEWS, ROCK,POP, or JAZZ. Thedisplay will show which mode the receiver is in. To return to the manual mode, press and release AUTO TONE until MAN (manual) appears in the display. This will return the tone adjustment to the TREB and BASS controls. Also, any time a TREB or BASS control is rotated, is automatically set back to MAN tone (manual). 3-15