2010 Jeep Grand Cherokee User Guide - Page 35

ELECTRONICS ELECTRONIC VEHICLE INFORMATION CENTER (EVIC) • The EVIC features a driver interactive display that is located in the instrument cluster. Pressing the controls on the steering wheel allows the driver to select vehicle information and Personal Settings. For additional information, refer to Programmable Features in this guide. button and the mode displayed will change between • Press and release the MENU Compass/Temperature, Trip, System Status, and Personal settings. button to scroll through sub menus (i.e., Trip Functions, Avg. Fuel • Press the STEP Economy, DTE, Elapsed Time, and Units). • Press and release the Compass/Temperature Compass/Temperature screens. • Press the RESET button for instant access to the button to RESET Trip Functions and change Personal Settings. UNIVERSAL GARAGE DOOR OPENER Programming HomeLink® Begin Programming • The HomeLink® buttons are located in the overhead console. • Erase all channels before you begin training by holding the two outside buttons for up to 20 seconds until "CHANNELS CLEARED" appears in the EVIC display. • Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN position. • Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink® buttons while keeping the EVIC display in view. Simultaneously, press and hold both the chosen HomeLink® button and the hand-held transmitter button until the EVIC display changes from "CHANNEL # TRAINING" to "CHANNEL # TRAINED." This may take up to 30 seconds, or longer in rare cases. • Press and hold the just-trained HomeLink® button; if the channel has been trained, the EVIC display will show "CHANNEL # TRANSMIT" and the device should operate. 33