2015 Jeep Grand Cherokee User Guide - Page 197

WHAT TO DO IN EMERGENCIES - Park/Headlight ON Indicator This indicator will illuminate when the park lights or headlights are turned on. - Vehicle Security Light This light will flash rapidly for approximately 15 seconds when the vehicle security alarm is arming. The light will flash at a slower speed continuously after the alarm is set. The security light will also come on for about three seconds when the ignition is first turned on. - Electronic Speed Control ON Indicator This indicator will illuminate when the electronic speed control has been activated to the "ON" position. - Electronic Speed Control SET Indicator This indicator will illuminate when the cruising speed has been set. - Hill Descent Control Indicator - If Equipped This indicator will illuminate when Hill Descent Control (HDC) has been selected using the Hill Descent Control Switch. - Door Ajar Indicator This indicator will illuminate when a door(s) is left ajar and not fully closed. - Electronic Stability Control (ESC) OFF Indicator Light This light indicates the Electronic Stability Control (ESC) is off. - Windshield Washer Fluid Low Indicator This indicator will illuminate when the windshield washer fluid is low. - Liftgate Ajar Indicator - If Equipped This indicator will illuminate when the liftgate is left ajar and not fully closed. Engine Oil Life Reset Oil Change Required Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message will display in the DID for five seconds after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate, dependent upon your personal driving style. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position or cycle the ignition to the ON/RUN position if equipped with Keyless Enter-N-Go™. To turn off the message temporarily, press and release the OK button. To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure. 195