1999 Lincoln Continental Owner Guide 1st Printing - Page 72

Controls and features 2. Locate the compass module mounted at the base of mirror. 3. Turn the ignition to the ON position. 4. Insert an appropriate diameter rod (paperclip) into the right switch access hole underneath the compass module and gently press for 1 to 2 seconds until ZONE and the current zone setting are displayed on the upper right corner of the mirror. 5. Release the switch, then slowly press it down again. Press the switch repeatedly until the correct zone setting for your geographic location is displayed on the upper right corner of the mirror. 6. To exit the zone setting mode, release pressure from the switch for greater than two seconds. Compass calibration adjustment Perform this adjustment in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) and make sure all vehicle doors are shut. 1. Start the vehicle. 2. Locate the compass module mounted on the base of mirror. 3. Insert an appropriate diameter rod (paperclip) into the left switch access hole underneath the compass module. 4. Gently press the switch for 1 to 2 seconds until CAL and a direction are displayed on the upper right corner of the mirror. (To exit CAL before performing a compass adjustment, turn the ignition to OFF.) 72