2002 Lincoln Town Car Owner Guide 1st Printing - Page 72

Driver Controls The 2nd or 3rd press from step 3 will activate the door. The HomeLink௡ Universal Transceiver has now been trained to the receiver. The remaining two buttons may now be programmed if this has not previously been done. Erasing HomeLinkா buttons Individual buttons cannot be erased, however, to erase the three programmed buttons: 1. Hold down the two outside buttons until the red light begins to flash after 20 seconds. 2. Release both buttons. Reprogramming a single HomeLinkா button To program a device to HomeLink௡ using a HomeLink௡ button previously trained, follow these steps: 1. Press and hold the desired HomeLink௡ button. Do NOT release until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 5-14 cm (2 to 5 inches) away from the HomeLink௡ surface. 3. Press and hold the hand-held transmitter button. 4. The HomeLink௡ indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. The previous device has now been erased and the new device can be activated by pushing the HomeLink௡ button that has just been programmed. Canadian Programming During programming, your hand-held transmitter may automatically stop transmitting after two seconds which may not be long enough to program the HomeLink௡ Universal Transceiver. 72