2006 Mercury Grand Marquis Owner Guide 2nd Printing - Page 91

Locks and Security 5. Turn the ignition back to the 3 (ON) position. 6. The door locks will lock/unlock to confirm programming mode is entered/active. 7. With the ignition still in the 3 (ON) position, for the autolock feature, press the unlock control once then press the lock control once. The horn will chirp once to confirm successful programming. For the auto-unlock feature, press the lock control once, then press the unlock control once. The horn will chirp twice to confirm successful programming. 8. After having waited the necessary time for the programming to confirm, turn the ignition to the 1 (OFF/LOCK) position. Once disabled, the autolock feature can be enabled by repeating the procedure in Steps 1-8. KEYLESS ENTRY SYSTEM (IF EQUIPPED) With the keyless entry keypad, you can: 1 2 3 4 5 6 7 8 9 0 • lock or unlock the vehicle doors without using the key. • open the trunk. See also Remote entry system in this chapter for more information. Your vehicle has a factory-set 5-digit code that operates the keyless entry system. You can also program your own 5-digit personal entry code. The factory-set code is located: • On the owner's wallet card in the glove compartment, or • At your dealer. When using the keyless entry keypad, press the middle of each button in order to ensure a good activation. Programming a personal entry code You can program up to three personal codes to unlock your vehicle. These codes do not replace the permanent code that the authorized dealer gave you. To create your own personal entry code: 1. Enter the factory set code. Note: The keypad will illuminate when pressed. 91 2006 Grand Marquis (grn) Owners Guide (post-2002-fmt) USA (fus)