2007 Nissan Versa Owner's Manual - Page 191
2007 Nissan Versa Manual
Page 191 highlights
CAUTION When stopping the vehicle on an uphill grade, do not hold the vehicle by depressing the accelerator pedal. The foot brake should be used for this purpose. The CVT in your vehicle is electronically controlled to produce maximum power and smooth operation. The recommended operating procedures for this transmission are shown on the following pages. Follow these procedures for maximum vehicle performance and driving enjoyment. NOTE: Engine power may be automatically reduced to protect the CVT if the engine speed increases quickly when driving on slippery roads or while being tested on some dynamometers. Starting the vehicle 1. After starting the engine, fully depress the foot brake pedal before attempting to move the shift selector lever out of the P (Park) position. 2. Keep the foot brake pedal depressed and move the shift selector lever into a driving gear. 3. Release the foot brake, then gradually start the vehicle in motion. 4. Stop the vehicle completely before attempting to shift the selector lever to the P (Park) position. The CVT is designed so the foot brake pedal MUST be depressed before shifting from P (Park) to any drive position while the ignition switch is in the ON position. The shift selector lever cannot be moved out of P (Park) and into any of the other gear positions if the ignition key is turned to the LOCK, OFF or ACC position or if the key is removed. To move the selector lever: Push the button brake pedal Push the button A WSD0194 while depressing the to shift A A Shift without pushing button Shifting After starting the engine, fully depress the brake pedal and move the shift selector lever from P (Park) to any of the desired shift positions. Starting and driving 5-17