2015 Nissan Versa Owner's Manual - Page 94

The may also come on steady if the fuelfiller cap is loose or missing, or if the vehicle runs out of fuel. Check to make sure the fuel-filler cap is installed and closed tightly, and that the vehicle has at least 3 gal (11.4 L) of fuel in the fuel tank. light should After a few driving trips, the turn off if no other potential emission control system malfunction exists. If this indicator light comes on steady for 20 seconds and then blinks for 10 seconds when the engine is not running, it indicates that the vehicle is not ready for an emission control system inspection/maintenance test. See "Readiness for inspection/maintenance (I/M) test" in the "Technical and consumer information" section of this manual. Operation The MIL will come on in one of two ways: ● MIL on steady - An emission control system malfunction has been detected. Check the fuel-filler cap. If the LOOSE FUEL CAP warning message is displayed in the odometer, and the fuel-filler cap is loose or missing, tighten or install the cap and continue to light should turn drive the vehicle. The light off after a few driving trips. If the does not turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. ● MIL blinking - An engine misfire has been detected which may damage the emission control system. To reduce or avoid emission control system damage: - do not drive at speeds above 45 MPH (72 km/h); - avoid hard acceleration or deceleration; - avoid steep uphill grades; - if possible, reduce the amount of cargo being hauled. The MIL may stop blinking and come on steady. Have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. CAUTION Continued vehicle operation without having the emission control system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system. Overdrive OFF indicator light (CVT models) (if so equipped) The overdrive OFF indicator light illuminates when the overdrive off mode is selected. For additional information, see "Continuously Variable Transmission (CVT)" in the "Starting and driving" section of this manual. Security indicator light For vehicles without Intelligent Key: This light blinks whenever the ignition switch is placed in the LOCK, OFF or ACC position. For vehicles with Intelligent Key: This light blinks when the ignition switch is placed in the LOCK position with the key removed from the ignition switch. The blinking security indicator light indicates that the security systems equipped on the vehicle are operational. Instruments and controls 2-19