2000 Saab 9-5 Owner's Manual - Page 173

Car care and technical information 173 Transmission fluid WARNING • Prolonged and repeated exposure of the skin to engine oil can cause serious skin disorders. • Avoid prolonged skin contact whenever possible. Wash the affected area thoroughly with soap and water after any contact. • Keep oil out of reach of children. • Do not touch the turbocharger or manifold. These get very hot when the engine has been running. • Do not spill oil on hot parts of the engine as this could cause a fire. • Protect the environment. Do not dispose of oil in the ground or down a drain. Dispose of all used oil and oil filters at an appropriate disposal facility. Manual transmission Check and top up the fluid in accordance with the service program. If original fluid cannot can be obtained for topping up (see page 231), automatic transmission fluid Dexron III (synthetic fluid) can be used. If so, the car should be taken to an authorized Saab dealer as soon as possible to have the reason for low fluid level corrected and original fluid installed. MAX +80° +80° MIN IB495 Automatic transmission Check the fluid level as follows: 1 Stand the car on level ground and apply the handbrake. The automatic transmission fluid must be at normal running temperature, approximately 175°F (80°C). This can be achieved by driving the car for about 30 min on the open road. 2 With the engine idling, move the selector lever to D and wait for at least 15 seconds. Next, move the selector lever to R and wait for 15 seconds again. Finally, move the selector lever to P. Let the engine idle. 3 Wipe the dipstick clean with a lint-free cloth and put it back. 4 With the fluid at normal temperature, the level should be between the MAX and MIN marks on the dipstick. Top up, as necessary, with Texaco Texamatic Dexron III automatic transmission fluid (mineral oil-based), adding it through the dipstick pipe. The distance between Dipstick for automatic-transmission fluid the MIN and MAX marks on the dipstick corresponds to a volume of approximately 0.4 qts (0.4 liter). NOTE If there is a smell of burning fluid or the fluid is black, change the fluid. If the outside temperature is below 50°F (10°C), the fluid will not reach the specified temperature of 175°F (80°C). In this case, the correct fluid level may be 0.8 in (20 mm) below the MAX mark.