2006 Saab 9-3 Owner's Manual - Page 279
2006 Saab 9-3 Manual
Page 279 highlights
Car care 279 Waxing and polishing Do not wax a new car during the first three or four months. In fact, there is no need to polish the car before the paintwork has started to dull through oxidation. Other than in exceptional cases, do not use abrasive polishes containing a cutting agent on a new car. Always wash the car thoroughly before waxing or polishing. ble, the damaged area should be taken back to the bare metal. The metal should then be primed with two thin coats of primer applied by brush. After the primer has dried, apply several thin layers of topcoat until the surface of the repaired area is flush with the surrounding paintwork. Stir both primer and touch-up paint thoroughly before use and allow each coat to dry before applying the next. Touching up the paint Damaged paintwork should be treated as soon as it is discovered: the longer it is left, the greater the risk of corrosion. The anticorrosion warranty does not cover corrosion resulting from untreated defects. Paintwork damage sustained in a crash is usually extensive and can only be properly restored by professionals. However, you can repair small scratches and stone chip damage yourself. The necessary tools and materials, such as primer, touch-up paint and brushes, are available from a workshop. We recommend that you contact a Saab dealer. In the case of minor flaws in the paintwork, where the metal has not been exposed and an undamaged layer of paint remains, touch-up paint can usually be applied directly, after any dirt has been scraped away using a pointed knife. If corrosion has already set in, such as the result of stone-chip damage, use a pointed knife to scrape off all surface rust. If possi- Two-coat enamel As the name implies, two-coat enamel is applied in two operations. The first coat, the base color, contains the pigment, metal flakes and binder. The second coat consists of a clear enamel, which provides the final gloss for the paintwork and protects the base from moisture and environmental contaminants. Touch-up stone-chip damage as follows: 1 Thoroughly clean the damaged area. 2 Then apply the primer, base color and finally, the clear enamel. To achieve the best finish, apply two or three coats of primer. Surface treatment composition 1 2 3 4 5 6 7 Body panel Zinc (certain components only) 7.5 µm Phosphate coating 3 -5 µm Cathodic ED 23 µm Intermediate coat 35 µm Metallic base/solid base 11 µm Clear enamel 45 µm