1999 Subaru Impreza Owner's Manual - Page 154

J Program switching buttons (PROG) When the program switching buttons (" " and " " buttons) are pressed at the same time during playback, the tape travel indicators will switch and the player will begin playing back the opposite side of the tape. The same mechanism is automatically activated when the end of the tape is reached. This allows the opposite side of the tape to play, providing continuous playback. J Fast-forward button To fast-forward the tape, press the " " or " " button in the same direction to the tape travel indicator. To stop fast-forwarding, lightly press the opposite side of the " " or " " button. J Rewind button To rewind the tape, press the " " or " " button in the opposite direction to the tape travel indicator. To stop rewinding, lightly press the opposite side of the " " or " " button. J Stop and eject button ( ) When " " button is pressed, play back stops and the cassette tape is ejected. Before the ignition switch turn to the "OFF" position, eject the tape from the player. Always make certain that you remove the cassette tape. J Tape program sensor button (TPS) Press "TPS" button during playback to return to the beginning of the current selection or to skip to the beginning of the next selection. To use this function, press the "TPS" button to turn on the "TPS" indicator. If the fastforward button (FF) is then pressed, the player advances the tape to the beginning of the next selection and starts playing it. If the rewind button (REW) is pressed instead, the player rewinds the tape to the beginning of the current selection and starts replaying it. The "TPS" function may not operate properly under the following conditions: D When the recording level is low. D When there are long pauses in the middle of a selection. D When the tape contains verbal material such as conversations. 5-10