3Com 3C16755-US User Guide - Page 11

Stacking the Units Together The Rubber Feet The four self-adhesive rubber feet prevent your hub from moving around on your desk. Only stick the feet to the marked areas at each corner of the underside of your hub if you intend to place the unit directly on top of the desk. Do not fix the feet if you are going to use the clip. The Stacking Clip The stacking clip allows you to stack your OfficeConnect units together neatly and securely. CAUTION: You can stack up to a maximum of four units. Smaller units must be stacked above larger units. To fit the clip: 1 Place your unit on a flat surface. 2 Fit the clip across the top of the unit, as shown in Figure 2 (picture 1), ensuring that the longer sections of the fastening pieces are pointing downwards. 3 Align the fastening pieces over the slots found on each side of the unit. 4 Push the clip down gently to secure it, ensuring the fastening pieces snap into the slots on the unit. To fit another unit: 1 Rest the second unit on top of the clip and align it with the front of the unit below. 2 Press down gently on the unit to secure it onto the clip, ensuring the fastening pieces fit into the slots on the unit below, as shown in Figure 2 (picture 2). Figure 2 Stacking Your Units Together 1 Fastening 2 Piece Fastening Piece To remove the clip: 1 Remove the top unit together with the clip. If you hook a finger around one of the the fastening pieces and then pull it gently from out of the slot, the clip should come away with the upper unit attached to it. 2 Push the clip in the center, so it bends towards the base of the unit, and then separate once the clip is loose. 11