3Com 3c17300 Implementation Guide - Page 67
Placing a Port in a Single VLAN, support IEEE 802.1Q.
View all 3Com 3c17300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
VLANs and Your Switch 69 The IEEE 802.1Q standard defines how VLANs operate within an open packet-switched network. An 802.1Q compliant packet carries additional information that allows a switch to determine to which VLAN the port belongs. If a frame is carrying the additional information, it is known as tagged. To carry multiple VLANs across a single physical (backbone) link, each packet must be tagged with a VLAN identifier so that the Switches can identify which packets belong in which VLANs. To communicate between VLANs a router must be used. Placing a Port in a Once the information for a new VLAN has been defined, you can place a Single VLAN port in that VLAN. Creating an IEEE 802.1Q Tagged Link This method of tagging is defined in the IEEE 802.1Q standard, and allows a link to carry traffic for any of the VLANs defined on your Switch. 802.1Q tagging can only be used if the devices at both ends of a link support IEEE 802.1Q. To create an 802.1Q tagged link: 1 Ensure that the device at the other end of the link uses the same 802.1Q tags as your Switch, that is, the same VLAN IDs are configured (note that VLAN IDs are global across the network). 2 Place the Switch ports in the required VLANs as tagged members. 3 Place the port at the other end of the link as a tagged member of the same VLANs as the port on your Switch.