3Com 3c17300 Implementation Guide - Page 68
VLAN Configuration Examples, Using Untagged Connections, Using Untagged, Connections
View all 3Com 3c17300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
70 CHAPTER 8: SETTING UP VIRTUAL LANS VLAN Configuration Examples This section contains examples of simple VLAN configurations. It describes how to set up your switch to support simple untagged and tagged connections. Using Untagged Connections The simplest VLAN operates in a small network using a single switch. In this network there is no requirement to pass traffic for multiple VLANs across a link. All traffic is handled by the single Switch and therefore untagged connections can be used. The example shown in Figure 20 illustrates a single Switch connected to endstations and servers using untagged connections. Ports 1, 2 and 3 of the Switch belong to VLAN 1, ports 10, 11 and 12 belong to VLAN 2. VLANs 1 and 2 are completely separate and cannot communicate with each other. This provides additional security for your network. Figure 20 VLAN configuration example: Using untagged connections To set up the configuration shown in Figure 20: 1 Configure the VLANs Create VLAN 2 on the Switch. VLAN 1 is the default VLAN and already exists.