ASRock X58 Extreme6 User Manual - Page 38
HDLED Hard Drive Activity LED
View all ASRock X58 Extreme6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
HDLED (Hard Drive Activity LED): Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assign-ments are matched correctly. Chassis Speaker Header (4-pin SPEAKER 1) (see p.12 No. 17) 1 SPEAKER DUMMY DUMMY +5V Please connect the chassis speaker to this header. Power LED Header (3-pin PLED1) (see p.12 No. 18) 1 PLEDPLED+ PLED+ Please connect the chassis power LED to this header to indicate system power status. The LED is on when the system is operating. The LED keeps blinking in S1 state. The LED is off in S3/S4 state or S5 state (power off). Chassis, NB and Power Fan Connectors (4-pin CHA_FAN1) (see p.12 No. 28) FAN_SPEED_CONTROL GND +12V CHA_FAN_SPEED (3-pin CHA_FAN2) (see p.12 No. 42) GND +12V CHA_FAN_SPEED Please connect the fan cables to the fan connectors and match the black wire to the ground pin. (3-pin NB_FAN1) (see p.12 No. 40) GND +12V NB_FAN_SPEED (3-pin PWR_FAN1) (see p.12 No. 7) GND +12V PWR_FAN_SPEED CPU Fan Connectors (4-pin CPU_FAN1) (see p.12 No. 2) 1 2 3 4 Please connect the CPU fan cable to the connector and match the black wire to the ground pin. 38