ASRock Z77 Extreme6 User Manual - Page 39
Onboard Headers and Connectors - sata ports
View all ASRock Z77 Extreme6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
2.12 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! FDD connector (33-pin FLOPPY1) (see p.14 No. 33) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Serial ATA2 Connectors (SATA2_2_3: see p.14, No. 15) (SATA2_4_5: see p.14, No. 16) SATA2_4 SATA2_2 SATA2_5 SATA2_3 These four Serial ATA2 (SATA2) connectors support SATA data cables for internal storage devices. The current SATA2 interface allows up to 3.0 Gb/s data transfer rate. SATA3_1 SATA3_A2 SATA3_0 SATA3_A1 Serial ATA3 Connectors (SATA3_A1_A2: see p.14, No. 13) (SATA3_0_1: see p.14, No. 14) These four Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6.0 Gb/s data transfer rate. If the eSATA3 port on the rear I/O has been connected, the internal SATA3_A2 will not funtion. Serial ATA (SATA) Data Cable (Optional) Either end of the SATA data cable can be connected to the SATA / SATA2 / SATA3 hard disk or the SATA2 / SATA3 connector on this motherboard. 39