Adaptec AHA-1540C Installation Guide
Adaptec AHA-1540C - Storage Controller Fast SCSI 10 MBps Manual
 |
View all Adaptec AHA-1540C manuals
Add to My Manuals
Save this manual to your list of manuals |
Adaptec AHA-1540C manual content summary:
- Adaptec AHA-1540C | Installation Guide - Page 1
AHA-1540C/1542C Installation Guide - Adaptec AHA-1540C | Installation Guide - Page 2
This guide provides the steps required for basic installation of the AHA-1540C and AHA-1542C ISAto-SCSI Host Adapters. Procedures are the same for both adapters except when regarding the AHA1542C on-board floppy controller. Installation of your host adapter includes: 1. Installing the AHA (Adaptec - Adaptec AHA-1540C | Installation Guide - Page 3
The factory installed bus terminators on the AHA1540C/1542C are enabled by default. Host adapter AHA-1540C/1542C: 1. Complete this physical installation section. 2. Disable Host Adapter SCSI Termination by following the instructions and SCSI peripheral installation manual instructions to: 1. Replace - Adaptec AHA-1540C | Installation Guide - Page 4
memory. There should be no device drivers or TSR (terminate and stay resident) Adaptec I/O Operating Environment and support the AHA1540C/1542C without additional software. Current versions of SCO® UNIX, USL® UNIX, and Sunsoft® Interactive UNIX support the AHA-1540C/1542C directly. 6 Troubleshooting - Adaptec AHA-1540C | Installation Guide - Page 5
AHA-1540C • A table and text explaining host adapter termination can be found in sections 2 and 3 Note If switch sw1 is switched to On, host adapter termination will always be enabled regardless of the setting in the Configuration Software. 10 8 Adaptec Customer Support • The Adaptec instructions,
-
1 -
2 -
3 -
4 -
5
 |
 |
AHA-1540C/1542C
Installation Guide