Adaptec AHA-2940UW User Guide - Page 21
Installing the Device Driver Version 2.0 or Later, for Solaris/SPARC 2.5.1 or 2.6 - aha driver download
UPC - 760884128886
View all Adaptec AHA-2940UW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installation 4 Install the host adapter device driver, as described in the following section. Installing the Device Driver (Version 2.0 or Later) for Solaris/SPARC 2.5.1 or 2.6 You can install AHA-2940UW/OF and AHA-2944UW/OF device drivers either from a floppy disk or from the Adaptec Web Site. Follow the procedures below to install the device drivers. Installation from a Floppy Disk 1 Log on to the Solaris operating system as root. 1 Insert the 7800 Family Open Firmware Manager Set, v2.0 device driver installation diskette into the floppy drive. 2 At the superuser prompt (#), type the following command and press Enter: /etc/init.d/volmgt stop 3 Then type the following and press Enter: pkgadd -d /dev/fd0 The following software package is displayed: 1 ADPadp Adaptec 294X(U)W/394X(U)W/4944(U)W SCSI Host Adapter Driver (UltraSparc) release v2.00 4 Select the package by typing 1 or all and pressing Enter to install the device driver. 5 Press Y to answer yes to each question that follows. 6 When the following message is displayed, type q to quit the installation: Installation of was successful. 7 Reboot the system to enable the new device driver to take effect. 2-9 Downloaded from www.Manualslib.com manuals search engine