Adobe 12040118 Using Help - Page 13

Help Using Help Writing Scripts Back 13 Argument Usage -RStemplate where render_settings_template is the name of a template to apply render_settings_template to the render queue item. If the template does not exist, it is an error. Default is to use the render template already defined for the item. -OMtemplate output_module_template where output_module_template is the name of a template to apply to the output module. If the template does not exist, it is an error. Default is to use the template already defined for the output module. -output output_path where output_path is a file path or URI specifying the destination render file. Default is the path already in the project file. -log logfile_path where logfile_path is a file path or URI specifying the location of the log file. Default is stdout. -s start_frame where star t_frame is the first frame to render. Default is the start frame in the file. -e end_frame where end_frame is the last frame to render. Note, this is "inclusive;" the final frame is rendered. Default is the end frame in the file. -i increment where increment is the number of frames to advance before rendering a new frame. A value of 1 (the default) results in a normal rendering of all frames. Higher increments will repeat the same (frame increment-1) times and then render a new one, starting the cycle again. Higher values result in faster renders but choppier motion. Default is 1. -mem_usage image_cache_percent max_mem_percent where image_cache_percent specifies the maximum percent of memory used to cache already rendered images/footage, and max_mem_percent specifies the total percent of memory that can be used by After Effects. -v verbose_flag where verbose_flag specifies the type of messages reported. Possible values are ERRORS (prints only fatal and problem errors) or ERRORS_AND_PROGRESS (prints progress of rendering as well). Default value is ERRORS_AND_PROGRESS. -close close_flag where close_flag specifies whether or not toclose the project when done rendering, and whether or not to save changes. If close_flag is D O_NOT_SAVE_CHANGES , the project is closed without saving changes. If close_flag is SAVE_CHANGES, project is closed and changes are saved. If c l o s e _ fl a g is D O _ N OT _ C LO S E the project is left open; but the project is left open only if using an already-running instance of After Effects, since new invocations of After Effects must always close and quit when done. Default value is D O_NOT_SAVE_CHANGES . Using Help Back 13