Amana AGG200AA Installation Instruction - Page 17

4. Remove the cap from the gas pressure regulator using a flat-blade screwdriver. NOTE: Do not remove the spring beneath the cap. A 4. Install the Natural gas orifice spuds using a 7 mm combination wrench. A. Cap 5. Turn the cap over so that N or NAT is visible. A 6. Reinstall the cap. A. Cap To Convert Surface Burners 1. Remove burner grate, burner caps and burners. A B A B A. Spud B. Holder NOTE: This range is equipped with 2 standard burners and 2 super burners. Spud size and location remain the same. 2 superburners.Spud size/location rem ain the sam e. Standard Burner 125 Super Burner 149 Super Burner 149 Standard Burner 125 A. Burner cap B. Burner 2. Locate the Natural gas orifice spuds for top burners in the package containing literature included with the range. Two Natural gas spuds are stamped "149" and two "125." 3. Remove the LP gas orifice spuds using a 7 mm combination wrench. 5. Place LP gas orifice spuds in the parts bag for future use and keep with the package containing literature. 6. Reinstall burners, burner caps and burner grates. 17