Asko D5536XXLFI Installation instructions EN - Page 8
If installing in a metal cabinet, the holes for
View all Asko D5536XXLFI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
STEP 1. FITTING THE DISHWASHER IN PLACE 6. Adjust the front feet by turning them clockwise to raise or counterclockwise to lower the dishwasher. Leave enough space to adjust them later. 7. Screw in the back foot completely by turning the adjustment screw at the front counterclockwise. Use a flat-bladed screwdriver or a 1/4˝ nut driver. (Only models with front adjustable rear foot). If the machine does not have a front adjustable rear foot, level the remaining rear legs just as you did the front legs. 8. Push the dishwasher into the cabinet. At the same time, pull the power cord, the drain hose, and the fill hose through the appropriate cut outs. Use caution when sliding the dishwasher into place. The protective slides could cause damage to certain types of soft flooring. NOTE: If installing in a metal cabinet, the hole(s) for the drain hose and connection pipe must be fitted with edge protectors/rubber grommets. 9. Lift the dishwasher a little at the front and turn the front feet to lower them. 1˝ (24 mm) 10. Check that the height of the machine corresponds to the height from the floor to the bottom edge of the counter top. 1˝ (24 mm) 8 CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM