Asko T208CW Installation Instructions English - Page 9

DRAINING THE CONDENSATE The moisture from the laundry is extracted in the condenser unit and accumulated in the condensate tank. Condensate tank has to be emptied regularly (see chapter "CLEANING AND MAINTENANCE" in the instructions for use.). Interruption of the drying cycle due to full condensate tank can be avoided by running the condensate discharge hose found at the back of the appliance directly into a drain. A If you decide to run the condensate drain hose into a drain, siphon, or washbasin, make sure the hose is securely fastened. This will prevent any water spillage which could result in unexpected damage. Always use hoses that are supplied with the appliance. If the dryer is connected to an air exhaust system already used for another appliance, a nonreturn valve must be installed. Return flow into the dryer could damage the appliance and the nonreturn valve prevents such flow. max 11.8" max 300 mm max 11.8" max 300 mm max 39.4" max 1000 mm Remove the small short hose from the attachment (A). B C D Connect the supplied drain hose to the same attachment (A). Run the condensate drain hose into a drain. Tie the hose onto a tap (B) so that it cannot slip during use. The drain hose can also be fed into the washbasin siphon (C) or directly into the floor drain (D). Then, the water is pumped directly into a washbasin, a siphon, or a floor drain. Do not pull the drain hose, and make sure it is not under tension, clamped, or bent. Customer Care Center, 1-800-898-1879, www.askona.com 9