Asko T711 User manual Use & Care Guide EN - Page 21

ENGLISH CHANGING THE LANGUAGE ON THE LCD DISPLAY There are eleven languages available for the LCD window: ♦ English ♦ French ♦ Spanish ♦ Portuguese ♦ Italian ♦ German ♦ Swedish ♦ Danish ♦ Norwegian ♦ Netherlands ♦ Finnish To change the language, follow the steps below: 1. Turn the machine off then on again. 2. Press ENTER five times in succession then press P1 five times. (This must be done within 15 seconds.) 3. When the Language menu displays, press an Arrow button to advance through the menu to the desired language. 4. Once the correct language displays, press ENTER to program the LCD window to display the language you selected. CHILD-SAFE START As a safety measure, you can program the T761 and T781 not to start unless the Start button is held down for three seconds. To do this, follow the steps below: 1. Turn the machine off then on. 2. Press ENTER five times, then press P3 five times. (This must be done within 15 seconds.) 3. "Delayed start" displays with "0" flashing in the lower right corner. Press the Right Arrow button to toggle the display to "3." CHILD-SAFE MENU BUTTON Please note that when you set the child-safe Start button, the Menu button is automatically programmed to delay for three seconds before it becomes active. This prevents a child from accidentally changing the program settings. When you want to change a program, press the Menu button for three seconds to activate the menus. The Menu button will work normally (without the 3-second delay) until you have completed your changes. If it is not pressed for two minutes, it will automatically revert back to the child-safe mode. T761 AND T781 ERROR MESSAGES Error messages will display in the LCD window if a fault occurs while a program is in progress. The table below defines each possible error message. If the message still displays after you have checked the possible solutions, call a service technician. ERROR MESSAGE Maximum program time Overflow (T781) Sensor Thermistor SOLUTION Make sure both fuses are intact. Clean the lint filter. Make sure exhaust hose is clear (T761). Clear message by turning the power off then on. Make sure the condensed water container is empty. If draining into a drain pipe, make sure the black rubber hose is not kinked or blocked. The drain should not be higher than 40 inches from the floor. Make sure the condensation pump is not blocked. This can appear if there are dry clothes in the drum when the unit is started. Cancel the error message by opening the door or turning the power off then on. Call a service technician. Page 21