Asus P5GZ-MX Motherboard Installation Guide - Page 45
P5GZ-MX, Front Panel Audio Connector, Intrusion Connector
View all Asus P5GZ-MX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
9. Front panel audio connector (10-1 pin AAFP) This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC'97 audio standard. Azalia-compliant Legacy AC'97-compliant pin definition pin definition AGND PRESENSE# MIC2_JD HP_HD AGND NC NC NC P5GZ-MX MIC2_L MIC2_R Line out_R NC Line out_L MIC2_L MIC2_R HP_R Jack_Sense HP_L AAFP R P5GZ-MX Front Panel Audio Connector • We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard's highdefinition audio capability. • By default, this connector is set to AC97 Audio. If you want to connect a High Definition front panel audio module to this connector, set the Front Panel Support Type item in the BIOS to [HD Audio]. See section "2.4.6 Onboard Device Configuration" for details. 10. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. P5GZ-MX +5VSB_MB Chassis Signal GND CHASSIS (Default) R P5GZ-MX Intrusion Connector ASUS P5GZ-MX 1-33